OPERATION
3-1-11
Using the [
⇑
×
10] and [
⇓
÷
10] keys
When a parameter has been selected via the numerical key pad, its value can be
incremented or decremented either in steps using the [
⇑
] key and the [
⇓
]
key, or continuously
with the control knob. Select
[Carrier Freq.]
and observe that the effect of pressing the [
⇑
] and
[
⇓
] keys is to change the carrier frequency in steps of 1 kHz. Default step sizes are assigned to
all parameters but these can be changed, see Page 3-1-42, 'INCREMENTING (using the delta
function)'.
Using the control knob
(1)
Press [KNOB UP-DN] to enable the control knob.
(2)
On the display, brackets will appear above and below the selected parameter.
These brackets embrace the part of the value which the control knob can change.
Pressing the [
×
10] key shortens the bracket length by one decimal place. Pressing
the [
÷
10]
key
increases the bracket length by one decimal place. In this way the
sensitivity of the control knob can be increased or decreased by a factor of ten.
(3)
Rotate the control knob and observe the change in the selected parameter. Press
[KNOB UP-DN] to disable the knob.
(4)
For other parameters, press the relevant soft key and use the [
⇑
] and [
⇓
] keys or
the control knob.
Note...
For
RF Level
the knob resolution is fixed at 0.1 dB.
