TS0
8
/1
5
Assembly
www.aerocompact.com
19
Continue placing the modules row by row.
Make sure that the modules are installed in a line.
Tighten the screws of the end clamps with 15 Nm or 11 ft lb each.
Reposition / replace clamps
Demount clamp: Unscrew the screw at the clamp completely.
Depending on the mounting situation, squeeze the clamp laterally and pull it out or pull it laterally out of
the rail.
Bonding
For bonding, AEROCOMPACT provides the bonding wire clamp as an accessory. These are each moun-
ted on the support rails.
Dependent on the mounting setting, each module row is bonded by the module clamps with grounding
pins.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
