AEREX 0040.0420, Operation And Maintenance Instructions

Page: 33 / 56

33 www.aerex.de
Reco-Boxx ZXR / ZXA / Flat – Operation and maintenance instructions [03/ 2021]
0-10V output
The controller has as a standard feature two configur-
able analogue 0...10V outputs. The outputs represent
the actual airflow (or torque) or the actual pressure
delivered by one of the selected fans.
Setting Settings range Factory
setting
Output 1 Flow Fan 1
Pressure Fan 1
Flow Fan 2
Pressure Fan 2
Flow Fan 3
Pressure Fan 3
Flow Fan 4
Pressure Fan 4
Torque Fan 1
Torque Fan 2
Torque Fan 3
Torque Fan 4 Flow Fan 1
Output 2 Flow Fan 1
Pressure Fan 1
Flow Fan 2
Pressure Fan 2
Flow Fan 3
Pressure Fan 3
Flow Fan 4
Pressure Fan 4
Torque Fan 1
Torque Fan 2
Torque Fan 3
Torque Fan 4 Pressure
Fan 1
Modbus configuration
The MODBUS RTU communication requires an ad-
ditional satellite circuit (CID050043) which is used as
communication interface. The communication protocol
used is MODBUS RTU, RS485.
Setting Settings range Factory setting
Adress 1...247 1
Baudrate 1200
4800
9600
19200 9600
Parity No
Yes No
LAN configuration
The MODBUS TCP/IP communication requires an ad-
ditional satellite circuit (CID 025072) which is used as
communication interface. The communication proto-
col used is Modbus TCP/IP on Ethernet network over
twisted pair 10 BASE T/100Base-TX IEEE 802.3.
Setting Settings range Factory setting
IP configuration DHCP
Manual
Manual
IP adress 192.168.1.1
Netmask 255.255.255.0
Gatway 0.0.0.0
Operating time
For maintenance purposes, operating timers can be
activated. If the “service alarm time” or the “Stop
fan” timers are triggered, the according alarm will be
shown and the unit will switch to “OFF”-mode.
Setting Settings range Factory setting
Reset timer No
Yes No
Fan run time activation No
Yes
No
Display time No
Yes No
Service alarm time 0...999999 h 0 h
Stop fan 0...999999 h 0 h