MFC Series Boilers User Manual
CHAPTER 9 – MFC 4000/6000 GAS ONLY BURNER
Page
98
of
170
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, NY 10913
OMM-0104_94
12/29/2015
Ph.: 800-526-0288
GF-146
9.4 Startup for MFC 4000-6000 Gas Only Burner
Starting the Burner
1. Turn on electricity to the burner by turning the power switch on the boiler panel to ON.
2. Close the thermostats/pressure switches and set the parameters on the RWF 40 regulator.
Please refer to the appropriate manual for instructions to perform this operation.
3. In
Figure 9-10, turn the On/Off switch to the
“ON”
position and turn the other switch to
“LOCAL”
.
Figure 9-10: Burner Controls Used for Startup
DANGER!
Make sure that the lamps or testers connected to the solenoids, or indicator lights on the
solenoids themselves, show that no voltage is present. If voltage is present, stop the burner
immediately
and check the electrical wiring.
NOTE:
For the start-up procedure and the parameters calibration, refer to the specific instruction
manual of the LMV37 electronic cam, supplied with the burner.
DIRECTION OF
MOTOR
ROTATION
