AEO-WP40SP10-KIT
10W SOLAR PANEL & DC WATER PUMP KIT
USER MANUAL
Place the Water Pump under water
BEFORE
connecting to a power source.
The water pump may become damaged if it is not under water before powering it on.
The plugs on the power cable connected to the Solar Panel (1) and power cable connected to the Water
Pump (2) must match in polarity (+ -). Connect the two plugs by matching the flat sides.
(See fig. 2.3 in
Section 2.)
This is a DC (Direct Current) water pump. DO NOT connect to any AC power.
The performance of the pump depends on sunlight intensity and the angle at which sunlight strikes the
solar panel surface. For safety purposes, the Solar Panel is at recommended 18V, because a 24V solar
panel actual output will exceeds its nominal voltage when sunlight at highest intensity.
Please carefully read this user manual before installing the pump.
Section 1: INCLUDED
Section 2: CAUTIONS
1)
Make sure the water pump is fully submerged underwater while it is operating.
2)
Do not connect the pump to any AC power supply; it is designed ONLY for DC power. The Solar Panel included is 18V
because the output is usually greater.
3)
The polarity of the power cable plug on the Water Pump (2) must match the plug
on the Solar Panel (1) as shown in the figure to the right. Connect the two plugs by
matching the flat sides; do not force them together.
4) Any alteration of the product itself or changing of the components voids
warranty.
5) Operate the pump in water only (under 104
°F
), and keep it away from
flammable liquids.
6) Do not let the pump run dry; it does not have dry-run protection.
Section 3: ASSEMBLY
*Unpack all components carefully.
1.
[Setup Water Pump
]
a.
Connect the nozzles tubes (adjust the height by the number of tubes) to the water pump outlet to produce
a
(1) Solar Panel
(2) Water Pump
(3) Ground Spike
(4) Nozzle Kit
