Installation and Operation Manual
AENO
TM
electric blender
Document version: 1.0.2, aeno.com
©
ASBISc Enterprises PLC. All rights reserved
Page
22
of
47
1.5.5 Setting the Blade Speed
Manual adjustment of the grinding speed allows you to achieve the desired
consistency of the finished mixture.
To turn on the device with individual blade speed settings, place the ingredient bowl
on the blender body and follow the steps below:
•
Plug the device into an outlet.
•
Press the "ON/OFF" button.
•
Press "Manual" button and use the "Speed+" and "Speed−" buttons to adjust
the
blade speed (1 to 9) and press the "ON/OFF" button.
•
If "ON/OFF" button is not pressed after adjusting the speed, the blender will go
into standby mode in 30 (thirty) seconds.
The device will operate at the selected speed.
1.5.6 Self-cleaning mode
In self-cleaning mode, the device removes food residue from the walls of the bowl and
the blade mechanism of the device.
To activate the self-cleaning mode, after removing the final product from the blender
bowl, pour 500 ml of warm water with a few drops of neutral dishwashing detergent
into it. * Close both covers and press the CLEANING button.
The blender blade mechanism will rotate as long as you hold down the CLEANING
button. After you finish cleaning, rinse the inside of the bowl with clean warm water
and wipe with a dry cloth. Be careful not to be injured by the blender's sharp blades.
1.5.7 Delayed start mode
To activate the device in the delayed start mode, place the bowl with the ingredients
on the blender body and perform the following actions:
•
Plug the device into an outlet.
•
Press "ON/OFF" button
•
Press "Preset Time" button. Then use buttons "Time +" and "Time
−
" to set the
desired
time
after which the device will start. The maximum allowable delayed
start time is24 hours.
* According to publicly available information, dishwashing detergents with a pH value of 5 to 8 are neutral.
