Wire Mapper Pro Model CA7028
5
CHAPTER 2
PRODUCT FEATURES
2.1 Description
The Wire Mapper Pro is a hand-held structured cable tester and trouble-
shooter designed for use on UTP, STP, FTP & SSTP cabling equipped with
RJ45 connectors and wired to either TIA 568A/B (ISO11801 & EN50137),
USOC or ISDN specifications. It detects open circuit pairs, shorts, crossed
wires, crossed pairs, reversed pairs, shield faults and split pairs.
In the event of opens and shorts, the Wire Mapper Pro uses TDR technology
to indicate if the fault is at the near end of the cable, the remote end, or if it is
somewhere in between. It will then indicate the distance to the fault.
The Wire Mapper Pro has the ability to measure and indicate the length of the
cable under test, using a Vp (Velocity of Propagation), set by the user. It will
measure and report the length of all 4 pairs of wires in the cable under test. It
also generates an audible tone that is transmitted into all 4 pairs on the cable
under test. This can be used for cable tracing and identification.
This instrument also has the ability to identify telephone and data lines. If the
main unit is plugged into an operational RJ45 socket, it will give a continuous
warning tone and appropriate display if a telephone voltage is present on any
of the pins. If the Service Detect key is pressed, it will give a display distin-
guishing 10base-T, Token Ring and connections.
Features:
Hand-held cable and troubleshooting tester
Designed for use on UTP, STP, FTP & SSTP cabling equipped
with RJ45 connectors and wired to either TIA568A/B (ISO11801 &
EN50137), USOC or ISDN specifications.
Detects open circuit pair, shorts, crossed wires, crossed pairs,
reversed pairs, shield faults and split pairs.
Indicates location of the fault
Measures and indicates the length of the cable under test
Emits an audible tone, used to trace a cable and identify the type of fault
Identifies telephone and data lines
Up to 16 Remote IDs identified
