Problem
Possible solution
The appliance door does not close.
Make sure that the installation of the filter is
correct.
Make sure that the laundry is not caught be‐
tween the appliance door and the rubber
seal.
The appliance stops during operation.
Make sure that the water container is emp‐
ty. Press Start/Pause to start the pro‐
gramme again.
Load is too small, increase the load or use
the Zeitprogramm (Time Drying programme.
The cycle time is too long or unsatisfactory
drying result.
1)
Make sure that the weight of the laundry is
suitable for the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in
the washing machine again.
Ensure that the room temperature is higher
than +5°C and lower than +35°C. Optimal
room temperature is 18°C to 25°C.
Set the Zeitprogramm (Time Drying or the
Extratrocken (Extra Dry) programme.
2)
The display shows
.
If you want to set a new programme, deacti‐
vate and activate the appliance.
Make sure that the options are suitable for
the programme.
1) After maximum 5 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not
satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The Heat Exchanger is clogged.
• There was too much laundry in the
appliance.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor ( See chapter "
Settings -
Adjustment of the remaining laundry
moisture degree
" for better setting).
• The airflow slots are clogged.
• Room temperature is too low or too
high ( optimal room temperature 18°C
to 25°C )
13. TECHNICAL DATA
Height x Width x Depth
850 x 596 x 638 mm (maximal 662 mm)
ENGLISH
23
