6.2 Wireless connection configuration
Before you begin configuration download and install AEG Home
application on your smart device.
1.
Push the On/Off button to switch on the appliance.
2.
Wait approximately 8 seconds.
3. Touch and hold the Refresh and Delay Start buttons
simultaneously for a few seconds until a 'click' sound is heard.
The symbols: and appear on the display. After few seconds
remains only flashing symbol: . Wireless module is activating
around 1 minute. When ready the symbol: (Access Point)
appears on the display. Access Point is open around 3 minutes.
4. Configure AEG Home application on your smart device.
If the configuration is successful the symbol: (Access Point)
disappears and the symbol: stops flashing.
Each time you switch the appliance on, the appliance attempt to
connect to the network automatically. When the connection is
established the symbol: stops flashing.
To switch off the wireless connection , touch and hold down
Refresh
and Delay Start buttons at the same time for 3
seconds. The symbol:
appears on the display.
Appliance stores last connection configuration. To use wireless
features of the appliance the wireless connection must be in
mode.
To remove the wireless credentials, touch and hold down
Refresh
and Delay Start buttons at the same time for 10 seconds.
The symbol:
appears on the display.
19/64
WI-FI - CONNECTIVITY SETUP
