8.11 Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Buzzer
option is activated, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
symbol signals the
execution of the anti-crease
phase. Laundry can be
removed during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds
to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level
settings. See chapter
Adjustment of
default dryness level
• Room temperature is too low or too
high. Optimal room temperature is
between 18°-25°C.
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which
are specified in the programmes
chapter.
• Clean the filter after each drying
cycle.
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• The water from the water container
can be used to iron the clothes. You
must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down the Dryness
Level and Anti-crease buttons at the
same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
5. Touch the Start/Pause button
repeatedly until you reach the
desired dryness level.
Dryness
level
Display symbol
Maximum
dryness
Extra dry‐
ness
Standard
dryness
6. To memorise the setting touch and
hold down the Dryness Level and
Anti-crease buttons at the same
time for approximately 2 seconds.
www.aeg.com
18
