AEG MSB2548C-M, User Manual

Page: 36 / 116

11. INSTALLATION
WARNING!
Refer to Safety chapters.
11.1 General Information
CAUTION!
Do not block the air vents. If
you do that, the appliance
can overheat.
CAUTION!
Do not connect the
appliance to adapters or
extension leads. This can
cause overloading and risk
of fire.
CAUTION!
The minimum installation
height is 85 cm.
• The microwave is for built-in use only.
It must be placed on a stable and flat
surface.
• The cabinet can not have a back wall
in the place where the microwave is
located.
• Put the microwave far away from
steam, hot air and water splashes.
• If the microwave is to close to the TV
and radio it may cause interference in
the received signal.
• If you transport the microwave in cold
weather, do not activate it
immediately after the installation. Let
is stand in the room temperature and
absorb the heat.
11.2 Electrical installation
WARNING!
Only a qualified person must
do the electrical installation.
The manufacturer is not
responsible if you do not
follow the safety precautions
from the chapter "Safety
Information".
This microwave is supplied with a main
cable and main plug.
The cable has an earth wire with an
earthing plug. The plug must be
plugged into an outlet that is properly
installed and earthed. In the event of an
electrical short circuit, earthing reduces
the risk of electric shock.
11.3 Installing the microwave
1. Check if the dimensions of the
furniture meet the installation
distances.
D
B
A
C
Installation distances
Dimension mm
A 450 + 2
B 560 + 8
C 550
D 45
2. Put the template on the bottom of
cabinet and check if it fits. If yes,
mark the spots for screws. Remove
the template and fix the bracket with
the screws (A) in the marked spot.
www.aeg.com 36