Installation and Connection Instructions
34
Installation on a concrete base
When installing on a concrete base,
for safety reasons it is imperative
that steel plates are installed, the
washing machine is then installed in
these plates. The steel plates are
available from customer service
under ET-No. 645 425 058.
Installation on vibrating
floors
In the case of floors that vibrate, especially wooden floors with floor-
boards that flex, a water-proof wooden panel of at least 15 mm thick-
ness must be firmly screwed to at least 2 floor beams. If possible, install
the appliance in a corner of the room: the wooden floor is more firmly
supported in the corners and thus has less tendency to resonant vibra-
tion.
Levelling on uneven floors
Using the four adjustable threaded feet, compensation can be made for
unevenness in the floor and the height of the appliance adjusted. The
height can be adjusted over the range +10... -5 mm.
To adjust the feet use the special spanner supplied for removing the
transport braces.
0
1.
Slide the special key firmly onto the hexagon head of the threaded foot
all the way to the stop.
2.
Adjust the threaded feet so that the appliance is level and sits stably.
The appliance must not rock across the corners when operating under
load.
3.
If necessary, check positioning with a spirit level.
Important!
Never compensate for small areas of unevenness in the
floor through the use of wooden wedges, cardboard or the like. Level-
ling should only ever be performed by adjusting the feet.
Summary of Contents for LAVAMAT W 1020
Page 1: ...LAVAMAT W 1020 Washing machine Instruction book ...
Page 44: ...44 ...
Page 45: ...45 ...
