Instructions for use
28
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (ENDE, FIN) lights up on the
program sequence display.
If you selected RINSE HOLD (SPÜLSTOPP, SANS ESSOR.), the indicator
next to the button START/PAUSE flashes.
0
1.
After a rinse hold, it is first necessary to pump off the water:
–
Press either the button START/PAUSE (water is pumped off and the
washing is spun according to the program which has just run; after
pressing the button START/PAUSE again, the spin speed can also still
be changed during spinning),
or
–
turn the program selector to OFF (AUS, ARRET) and then to PUMP
(PUMPEN, VIDANGE) and press the button START/PAUSE (water is
pumped off without spinning)
or
–
turn the program selector to OFF (AUS, ARRET) and then to SPIN
(SCHLEUDERN, ESSORAGE) or SHORT SPIN (SCHONSCHLEUDERN, ES-
SOR. DELICAT) and press the button START/ PAUSE (water is pumped
off and the washing is spun or gently spun).
After the end of this program step, the indicator END (ENDE, FIN) lights
up.
2.
Open the filling door.
As soon as the indicator DOOR (TÜR, PORTE) lights up green, the filling
door can be opened.
3.
Remove the washing.
4.
Turn the program selector to OFF (AUS, ARRET).
5.
After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If the display OVER DOSING (ÜBERDOSIERT, SURDOSAGE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash, pay
attention to the dosing information of the washing detergent
manufacturer and pay attention to the filling quantity!
Attention!
If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains. (The Aqua Control water protection does not function
if the power supply is interrupted).
