AEG LAVAMAT 97-115, Instruction Booklet, Page: 36 / 39

Water inlet
The appliance has
two inlet hoses,
hot and cold.
The inlets on the
back of the appli-
ance are colour
coded, blue for
cold and red for
hot.
Connect the water inlet hoses to separate taps for cold and hot water
with a 3/4" thread after having inserted the small filters “A” supplied
with the machine.
If only a cold water supply is available, connect the two hoses to a cold
water outlet by means of a “Y” connection piece, which is available
from your AEG Service Centre.
The other end of the inlet hoses which connects to the machine can be
turned in any direction. Simply loosen the fitting, rotate the hoses and
retighten the fitting, making sure there are no water leaks.
The inlet hoses must not be lengthened. If they are too short and you
do not wish to move the taps, you will have to purchase new, longer
hoses specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned
in three ways:
Hooked over the edge of a sink using the
plastic hose guide supplied with the
machine.
In this case, make sure the end
cannot come unhooked when the machine
is emptying.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This branch must be above the trap so that
the bend is at least 60 cm above the ground.
72
Installation
A