In case a selection is
not
possible
, no indicator comes
on and an acoustic signal
sounds.
10.6
Starting a programme
Touch the Start/Pause button to start the
programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing and the
maximum load indicator goes off.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
10.7
Starting a programme
with the delay start
1.
Touch the Delay Start button
repeatedly until the display shows
the desired delay time. The indicator
goes on.
2.
Touch the Start/Pause button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The PROSENSE estimation
starts at the end of the
countdown.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1.
Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2.
Touch the Delay Start button
repeatedly until the display shows .
3.
Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1.
Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2.
Touch the Delay Start button
repeatedly until the display shows
the desired delay time.
3.
Touch the Start/Pause button again
to start the new countdown.
10.8
The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load
.
After touching the Start/Pause button,
the maximum declared load indicator
goes off, the indicator
flashes, the
ProSense starts the laundry load
detection:
1.
The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum
rotates shortly.
2.
At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection,
in case
of drum overload
, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important!
If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
www.aeg.com
24
