AEG IAE8488SFB, User Manual

Page: 59 / 188

Problem Possible cause Remedy
You put too much salt in the water. Do not salt boiling water.
Temperature is not visible on the
display.
The display shows a warning icon.
The Food Sensor did not establish
connection with the hob because
the strength of the signal is too low.
Place the Food Sensor close to the
antenna on the hob surface, near
the centre of the hob. Refer to "Hints
and tips".
Something covers the Food Sensor
or the antenna on the hob surface,
e.g. a piece of metal cutlery.
Remove anything that covers the
antenna. Make sure you place cook‐
ware in the centre of the cooking
zone. Refer to "Hints and tips".
The connection between the Food
Sensor and the antenna was lost.
Make sure nothing covers the sig‐
nal. Move the Food Sensor along
the rim of the pot to adjust its posi‐
tion. Refer to "Hints and tips".
Other appliances work at the same
frequency and disturb the connec‐
tion.
Remove any appliances that may
disturb the connection. Refer to
"Technical Data".
Temperature of the food is different
than expected.
The Food Sensor is inserted incor‐
rectly.
Make sure the measurement point is
situated in the thickest part of the
food. Refer to "Hints and tips".
The hob detects significant tempera‐
ture jumps.
You added some water or changed
the pot while cooking.
Avoid adding water or changing the
pot after a function starts.
The heat in the pot did not spread
evenly, especially for thick liquids.
Stir the food frequently.
The pot gets too hot or the food is
overdone too quickly.
You used a pot which is too small. Use pots whose sizes are appropri‐
ate for a given cooking zone. Refer
to "Technical data".
You cannot activate a function. Another function is running on the
same cooking zone, which prevents
the activation.
Stop the function before you acti‐
vate another.
Assisted Cooking or Sous Vide
stops.
At the beginning of a cooking ses‐
sion the temperature of the liquid in‐
side the pot is higher than 40 °C.
The cookware in use is hot.
Use only cold liquids.
Do not preheat the cookware.
Hob²Hood does not work. You covered the control panel. Remove the object from the control
panel.
Hob²Hood operates, but only the
light is on.
You activated the H1 mode. Change the mode to H2 - H6 or wait
until the automatic mode starts.
Hob²Hood modes H1 - H6 operate,
but the light is off.
There might be a problem with the
light bulb.
Contact an Authorised Service Cen‐
tre.
There is no sound when you touch
the panel sensor fields.
The sounds are deactivated. Activate the sounds. Refer to "Daily
use".
ENGLISH 59