AEG GS45AVB, User Manual, Page: 62 / 72

How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
flashes and the
indicator is on with
fixed light.
2. Immediately press the programme
button.
The indicator stops flashing and
comes on with fixed light while the
indicator
starts to flash.
3. Wait until the indicator goes
off. The indicator
continues to flash.
The indicator shows the current
setting of the acoustic signal. (Factory
setting is with acoustic signal off).
• Indicator OFF = acoustic
signal OFF.
• Indicator ON = acoustic
signal ON.
4.
To change the setting, press the
programme button.
5. Press the on/off button to confirm
the setting.
7. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure will be repeated periodically.
7.1 The salt container
CAUTION!
Only use salt specifically
designed for dishwashers.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in the daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (Only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap of the salt container
clockwise to close the salt container.
www.aeg.com 62