7.3 How to activate the
wireless connection
Press and hold simultaneously and
for 2 seconds.
• The indicator
is on.
• The display shows On for a few
seconds.
• The appliance returns to the
programme selection.
Refer to "Daily use" to activate the
remote start.
7.4 How to reset the network
credentials
If you want to connect to a different
wireless network or update the
credentials of the current network, reset
the network credentials.
Press and hold simultaneously and
for about 5 seconds.
• The display shows Off and then
--- for a few seconds.
• The indicator
is off.
• The appliance returns to the
programme selection.
Connect the dishwasher to the network
and to the app to enter new network
credentials. Refer to the instructions
provided earlier in this chapter.
8. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme Quick to
remove any residuals from the
manufacturing process. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt
container (only for the first time).
3. Fill the salt container with dishwasher
salt (until it is full).
4. Carefully shake the funnel by its
handle to get the last granules inside.
5. Remove the salt around the opening
of the salt container.
ENGLISH
17