AEG FAV55VI2P, User Manual, Page: 10 / 28

6. BASIC SETTINGS
You can configure the appliance by
changing basic settings according to
your needs.
Number Setting Values
Description
1)
1 Water hardness From level 1L to
level 10L (de-
fault: 5L)
Adjust the level of the water softener ac-
cording to the water hardness in your area.
2 Rinse aid level From level 0A
to level 6A (de-
fault: 4A) Adjust the level of the rinse aid according
to the necessary dosage.
3 End sound On
Off (default) Activate or deactivate the acoustic signal
for the end of a programme.
4 Auto door open On (default)
Off
Activate or deactivate the AirDry.
5 Key tones On (default)
Off Activate or deactivate the sound of the
buttons when pressed.
6 Latest pro-
gramme selec-
tion On
Off (default) Enable or disable the automatic selection
of the most recently used programme and
options.
7 Display on floor On (default)
Off
Activate or deactivate the TimeBeam.
1)
For more details, refer to the information provided in this chapter.
You can change the basic settings in
setting mode.
When the appliance is in setting mode,
the bars of the ECOMETER represent
available settings. For each setting, a
dedicated bar of the ECOMETER flashes.
The order of the basic settings presented
in the table is also the order of the
settings on the ECOMETER:
1 2 3 4 5 6 7
6.1
The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
right level of the water softener to assure
good washing results.
www.aeg.com 10