background image

g

8

3

The ON/OFF switch (E) only catches 
when the kettle is on the base unit (F).

3

Do not use the water from the first 
boiling cycle to prepare food.

The automatic switch off

The kettle will switch itself off auto-
matically and the pilot light will go out 
when the water has boiled.
If you want to stop the heating process 
before the kettle automatically swit-
ches off, simply press the ON/OFF 
switch (E) up or lift up the jug from the 
base. If you want to reheat water 
which has already been heated, press 
the ON/OFF switch (E) down again. 
When the water is boiling the kettle 
switches itself off automatically.

Safety system

All AEG kettles are equipped with a 
boil-dry safety cut-out. This feature 
protects the appliance from over-
heating when started without water or 
from boiling until it is empty if used 
with the lid open. If the appliance is 
accidently switched on without water, 
it is automatically protected against 
overheating. The heating process is 
automatically interrupted. Before 
using the kettle again let it cool down 
for 5-10 minutes.

Cleaning and care

1

Always disconnect the kettle from the 
mains supply before cleaning.

1

Never clean the kettle and base unit 
under running water or immerse it in 
washing-up water.

0

Occasionally rinse out the kettle with 
clean water.

0

Clean the outside of the appliance only 
using a damp cloth. Do not use any 
caustic or abrasive cleansing agents.

Descaling

The appliance should be descaled regu-
larly depending on the level of the 
water hardness. Use a standard desca-
ler following the directions; preferably 
choose an environmentally friendly 
product.

0

First fill in water, then a standard des-
caling preparation which is not too 
strong.

1

Do not boil the solution as it could 
foam over.

0

After descaling, rinse the kettle out 
thoroughly with clean water. Never 
pour descaling agents into an enamel 
sink and do not reuse them.

Technical data

Mains voltage: 230V/50Hz
Power drain: 1800 W 

;

This appliance complies with the follo-
wing EC directives:

• 73/23/EEC of 19/2/1973 "Low voltage 

directive", including the modification 
directive 93/68/EEC.

• 89/336/EEC of 3/5/1989 "EMC direc-

tive", including the modification direc-
tive 92/31/EEC.

Customer service

The highest quality standards apply for 
our appliances. If nevertheless a distur-
bance should arise, for which you can 
find no solution in the operating 
instructions, please contact your retai-
ler or the AEG customer service.

Summary of Contents for EWA 176






Reviews: