AEG ECE455020B, User Manual

Page: 57 / 108

Problem Possible cause Remedy
and a number come on.
There is an error in the hob. Deactivate the hob and acti-
vate it again after 30 sec-
onds. If
comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
You can hear a constant
beep noise. The electrical connection is
incorrect. Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
7.2
If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8.
INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Hob and oven connection
type
This appliance has an yellow 1x14 pole
connector and can be connected to an
oven with an yellow 1x14 pole connector.
8.2 Before the installation
Before you install the hob, write down
the information bellow from the rating
plate. The rating plate is on the bottom
of the hob.
Serial number ...........................
8.3 Built-in hobs
First install the oven then the hob in its
cutout.
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
8.4 Assembly
min.
50mm
min.
500mm
ENGLISH 17