AEG CKB64100BW, User Manual

Page: 27 / 32

3. Put a cloth on the bottom of the
cavity.
The back lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable
300 °C heat-resistant lamp.
4. Install the glass cover.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 What to do if...
Problem Possible cause Remedy
There is no spark when you
try to activate the spark gen‐
erator.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Burner cap and crown are
placed incorrectly.
Place the burner cap and
crown correctly.
The flame extinguishes im‐
mediately after ignition.
Thermocouple is not heated
up sufficiently.
After lightning the flame,
keep the spark generator ac‐
tivated for equal or less than
10 seconds.
The flame ring is uneven. Burner crown is blocked with
food residues.
Make sure that the injector is
not blocked and the burner
crown is clean.
The burners do not work. There is no gas supply. Check the gas connection.
The flame colour is orange
or yellow.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
The oven does not heat up. The oven is deactivated. Activate the oven.
The necessary settings are
not set.
Make sure that the settings
are correct.
The lamp does not operate. The lamp is defective. Replace the lamp.
ENGLISH 27