AEG CDE84779XB, User Manual

Page: 24 / 64

some time to get rid of the remaining
moisture.
9.4 Cleaning the hood filter
The filter prevents grease particles from
getting into the hood system. The filter
has a built-in counter that reminds you
about cleaning. After 100 hours of use,
the filter indicator starts blinking. The
notification stays on for 30 seconds after
you deactivate the hood and the hob.
The notification does not
block the use of the hob.
To turn off the alarm: press . The
counter restarts.
To reset the alarm: press twice. The
indicator appears and the signal sounds.
It is recommended to clean the filter
before the indicator appears.
1. Remove the filter and filter housing
carefully. They are located right
under the grid in the centre of the
hob.
2. Clean the hood cavity with a cleaning
foam.
3. Wash the filter and filter housing
manually in warm water without using
detergents or abrasive sponges. You
can also wash them in a dishwasher
with the maximum temperature of
65-70 °C, without detergents and
without dishes in the same load.
4. Fix the filter and filter housing back in
place when they are fully dried.
The counter restarts automatically when
you turn on the hood for the first time.
Maximum number of cleaning cycles is 8.
After that time, the filter needs to be
replaced with a new one.
WARNING!
An oversaturated filter can
pose a risk of fire.
10. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
www.aeg.com 24