AEG BSE792320M BSK792320M, User Manual

Page: 12 / 68

Step 1 Step 2 Step 3 Step 4
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
Shake the test paper
to remove the excess
of water.
After 1 min, check
water hardness with
the table below.
Set the water hard‐
ness level in the
menu: Basic settings.
The colours of the test paper continue to change. Do not check water hardness later
than 1 min after test.
You can change the water hardness level in the menu: Basic settings / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium
deposit and the water classification. Adjust the water hardness level according to the
table.
Water hardness Test paper Calcium de‐
posit (mmol/l)
Calcium de‐
posit (mg/l)
Water classi‐
fication
Level dH
1 0 - 7 0 - 1.3 0 - 50 soft
2 8 - 14 1.4 - 2.5 51 - 100 moderately
hard
3 15 - 21 2.6 - 3.8 101 - 150 hard
4 ≥22 ≥ 3.9 ≥151 very hard
When the tap water hardness level is 4,
fill the water drawer with still bottled
water.
6. DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Navigating the menus
1. Turn on the oven.
2. Press
or to select the menu
option.
3. Press to move to the submenu or
accept the setting.
At each point you can go
back to the main menu with
.
6.2 Setting a heating function
1. Turn on the oven.
2. Select the menu: Heating Functions.
3. Press
to confirm.
4. Select a heating function.
5. Press
to confirm.
6. Set the temperature.
www.aeg.com 12