Components
Description
Remedy
The lamp is burnt out.
Replace the lamp, for details refer to "Care and
Cleaning" chapter, How to replace: Lamp.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
Remedy
C2 - the Food sensor is in the oven cavity dur‐
ing Pyrolytic Cleaning.
Take out the Food sensor.
C3 - the door is not fully closed during Pyrolyt‐
ic Cleaning.
Close the door.
F111 - Food sensor is not correctly inserted in‐
to the socket.
Fully plug Food sensor into the socket.
F240, F439 - the touch fields on the display do
not work properly.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
F908 - the oven system cannot connect with
the control panel.
Turn the oven off and on.
12.3 Service data
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the front
frame of the oven cavity. Do not remove the rating plate from the oven cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC)
.........................................
108/272
TROUBLESHOOTING
Summary of Contents for BD742P
Page 271: ...271 272 ...
