AEG BCO79821V3, User Manual

Page: 93 / 420

Problems with cleaning procedure
Description Possible cause Remedy
The water drawer is difficult to
clean.
The lid and the wave breaker
were not removed.
Remove the lid and the wave
breaker.
There is no water inside the
grill -/ roasting pan after des‐
caling.
The water drawer was not fil‐
led in to the maximum level.
Check if a descaling agent /
water is present in the water
drawer body.
There is dirty water on the
bottom of the cavity after des‐
caling.
The grill -/ roasting pan is on a
wrong shelf position.
Remove the remaining water
and the descaling agent from
the bottom of the oven. Next
time put the grill -/ roasting
pan on the first shelf position.
There is too much water on
the bottom of the cavity after
cleaning.
You put too much detergent in
the oven before you started
cleaning.
Next time evenly spread the
thin layer of a detergent on
the cavity walls.
Cleaning performance is not
satisfactory.
You started cleaning when the
oven was too hot.
Wait until the oven is cold. Re‐
peat cleaning.
You did not remove all the ac‐
cessories from the oven be‐
fore cleaning.
Remove all the accessories
from the oven. Repeat clean‐
ing.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description Remedy
F111 - Food sensor is not correctly inserted in‐
to the socket.
Fully plug Food sensor into the socket.
F240, F439 - the touch fields on the display do
not work properly.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
93/420
TROUBLESHOOTING