AEG AHB93321LW, User Manual

Page: 13 / 68

Problem Possible cause Solution
The compressor operates
continually. Temperature is set incorrect-
ly. Refer to "Operation" chap-
ter.
Large quantities of food to
be frozen were put in at the
same time. Wait some hours and then
check the temperature
again.
The room temperature is too
high. Refer to climate class chart
on the rating plate.
Food placed in the appli-
ance was too warm. Allow food to cool to room
temperature before storing.
The lid is not closed proper-
ly. Check if the lid closes well
and the gaskets are undam-
aged and clean.
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
There is too much frost and
ice. The lid is not closed correct-
ly or the gasket is deformed/
dirty. Refer to "Opening and clos-
ing the lid".
The water drainage plug is
not correctly positioned. Position the water drainage
plug in the correct way.
Temperature is set incorrect-
ly. Refer to "Operation" chap-
ter.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Temperature cannot be set. The FROSTMATIC function
is switched on. Refer to "FROSTMATIC
function".
The temperature in the ap-
pliance is too low/too high. The temperature regulator is
not set correctly. Set a higher/lower tempera-
ture.
The lid is not closed correct-
ly. Refer to "Opening and clos-
ing the lid".
The products' temperature
is too high. Let the product temperature
decrease to room tempera-
ture before storage.
Many products are stored at
the same time. Store less products at the
same time.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
ENGLISH 13