21
Things to note
•
The oven light will illuminate.
•
The indicator neon will glow. It may turn
ON and OFF during use to show that the
setting is being maintained.
•
The cooling fan for the controls may
operate after a time.
To fit the main oven shelves
The shelves should be fitted with the straight
rods uppermost on the frame and the forms
towards the back of the oven.
To remove a shelf slide the shelf towards
you until the shelf stop is reached. Tilt shelf
up at the front so that the stops clear the
side supports. Lift shelf clear. To install a
shelf, reverse the above steps. Each shelf
position has an upper and lower support
wire, ensure the shelf is placed between
these two support wires.
Using the telescopic runners
(where fitted)
Ensure the telescopic runners are pushed
back into the oven cavity before fitting the
shelf.
Holding the front edge of the shelf with both
hands, place the rear shelf forms over the
telescopic runners.
Slide the shelf into position, lifting slightly at
the front so that the shelf locates into the
retaining hooks.
To remove, raise the front edge and
withdraw the shelf.
Note:
Should you wish to purchase a telescopic
runner kit, this can be ordered from your
local Service Force Centre by quoting part
number (BAZ D02).
Form
Retaining
hook
