T
RUCK
C
AMPER
O
WNER
’
S
M
ANUAL
© ALP (Adventurer Limited Partnership).
15
All Rights Reserved
of jack before cranking. Be sure to reset locking lever to the “locked” (UP Position) when jacks
are not being cranked to avoid accidental extension/retraction.
Insert crank handle firmly into the crank socket of the jack. Starting at the front, begin
cranking.
Extend each jack no more than 4 - 6” at a time at all four corners starting with the front jacks,
keeping the camper level or the front slightly higher at all times. Repeat this process until the
camper is clear of the truck body bed by approximately 4 to 6“. (If there are two people
working the jacks, one on each side, it is a very easy task) the use of a cordless drill is a nice
accessory to speed up this process.
WARNING:
Never raise the back of your camper
higher than the front
See “Continuation for all Jack Versions” below to continue.
Operating Remote Control Electric Jacks
WARNING:
Do not over-extend or over-retract jacks. Each jack has built in stops. If excessive force
is applied against the stops, damage to the jacks may occur, this is usually noted by a ratchting
sound. Electric jacks need 12-volt automotive battery power to operate. The camper battery must be
charged and in good condition. If the battery is too low to operate the jacks, charge the battery
before using jacks. If the camper is on the truck, starting the truck’s engine will supply power to the
jacks as long as the 12-volt electrical cord is connected. If no power is available, use the manual
override operation noted above.
WARNING:
Do not use the electric jacks to raise or lower the camper using only 120-volt power.
The converter’s charger can be damaged if the jacks are operated with 120-volt power through the
12-volt converter without an automotive battery or with a low battery.
A well charged battery in good
condition is required.
NOTE:
Before operating the remote control electric camper jacks, be sure to read and understand
the operating instructions that were provided with your camper pertaining to their safe operation.
The jacks are operated with a hand held remote control. To activate, locate and press the two center
“all jacks” buttons simultaneously and then press the two top “Accessory” buttons simultaneously to
activate the remote. A light on the face of the remote will illuminate when activated. The remote is
on a time delay, that will automatically shutoff after 10 minutes of inactivity, this feature helps save
CAUTION:
Do NOT leave jacks in the unlocked
position for an extended period of time
