R3267 Series Spectrum Analyzer Operation Manual (Vol.1)
3.3.8 FORMAT Key (Display format)
3-40
3.3.8
FORMAT Key (Display format)
This section describes the Format menu displayed when the FORMAT Key is pressed.
Trace Detector
Displays the Trace Detector (Trace Det) menu.
Normal
Sets the normal detector mode which automatically detects posi-
tive or negative peaks for each trace point.
Positive
Sets the positive peak detector mode.
Negative
Sets the negative peak detector mode.
Sample
Sets the sample detector mode.
NOTE
If "Trace Point" is set to a value lower than the value calcu-
lated by Span/RBW, the level may not be displayed correctly.
If this happens, set "Trace Detector" to "Positive."
Display Line ON/OFF
Toggles the display line indication on or off. This line is used as
a base line when comparing trace levels.
ON:
Turns the display line on. The display line position can
be changed as necessary.
OFF:
Removes the display line.
XY Cursor
Displays the XY Cursor menu.
XY Cursor ON/OFF
Toggles the XY cursor on or off.
ON:
Displays the XY cursor.
OFF:
Removes the XY cursor.
X Cursor Position
Allows you to set the X cursor position.
Y Cursor Position
Allows you to set the Y cursor position.
Set Anchor
Displays an anchor marker at the intersection of the X- and Y-
cursors.
The X- and Y-values of the XY cursor are then expressed with
values relative to the anchor marker
Remove Anchor
Removes the anchor marker.
Limit Line
Displays Limit Line menu.
Limit Line Setup
Displays Limit Line Setup dialog box.
