Advantech WISE-6610 Series, User Manual, Page: 86 / 100

WISE-6610 Series User Manual 75
14. Click the Channel tab to configure the channel settings following the frequency
rule.
Figure 4.10 LoRaWAN Server > Infrastructure > Network > Create > Channel
Max Data Rate Enter a value to define the highest DR (lowest SF) supported by the
channels in this network. Additional channels may need to be given a
different value.
Note: The Max Data Rate is not always the last item (lowest SF)
in the TX data rate table. Not all channels (frequencies) are
allowed to use all data rates. For example, in EU868, the
default channels use SF12/125 to SF7/125 only. The SF7/250
is allowed for the 867.3 MHz channel only and FSK for 867.7
MHz only.
Initial RX1 DR Offset Enter a value to define the offset between the uplink and downlink
data rates used to communicate with the end-device on the first
reception slot (RX1).
Initial RX2 DR Enter a value to define the data rate for the second reception slot
(RX2).
Initial RX2 Freq
(MHz) Enter a value to define the default frequency in the RX2 receive
window.
Submit Click Submit to save the values and update the screen.
Item Description
Initial Channels Enter a range of values to define the initial channels including a
comma-separated list of intervals, e.g.
0-2
for EU and
0-71
for US.
Channels Click Add new channels to define a list of additional channels sent to
the device during Join (CFList).

Frequency (MHz): Enter a value to define the channel fre-
quency.

Min Data Rate: Enter a value to define the lowest data rate
allowed in this channel. Enter 0 if it's not specified.

Max Data Rate: Enter a value to define the highest data rate
allowed in this channel. Enter the global value of the
ADR tab if
it's not specified.
Submit Click Submit to save the values and update the screen.
Item Description