Advantech WISE-5580, User Manual

Page: 27 / 50

19 WISE-5580 User Manual
Chapter 3
Initial Setup
The default power mode is AT mode, the system will boot as long as one valid power
input from 1 or 2. Please check below LED to make sure the system is well powered.
NOTE: Please do not assemble or disassemble the system while the PWR /STBY
LED is on. Please make sure power is completely removed and every LED is off
before changing hardware configuration.
To enhance the system availability, WISE-5580 provides dual power input function to
support main power input and backup power input. Either power input encounter
trouble will trigger below alarms:
1. The LED "ERR VOL" turns "On"
2. The RL+ /RL- on the Power Input Terminal changes(Refer to p.20 ERR-
LOGIC1)
3. The system tag change and can be access remotely
3.2 System Configuration and Installation
Please refer to section 1.1, table 2 to do the necessary configuration or maintenance.
Please follow below step to open the front cover to do access the internal system
components:
Step1: Remove the 7 pins Power Input Wiring Terminal on the top of the device
Step2: Remove the USB/HDMI fix kit from the front cover (Option)
Step3: Remove 2 screws on the lower side of the front cover
Step4: Move the cover upward slightly and move forward.
User can do the following access:

Install the M.2 SSD storage
This is the storage for the operating system, and suggests using industrial grade
SSD to ensure the system reliability. Please refer to datasheet to check the
parts which has been verified to work well with the system.
After insert the SSD, please fix the SSD in the slot by the provided screw.

Install the PCIe-mini card module
User can install PCIe-mini card module in the PCIe-mini card slot. For example:
– NVRAM module: PCM-2300MR-AE
It provides the non-volatile memory for the system. This function is usually
necessary for running a softlogic system.
– Advantech EWM wireless module
Include Wi-Fi, 3G, LTE, GPS function available for optional expansion, there
is one hole reserve for antenna SMA connector on the top cover.
– Other 3rd party PCIe-mini card module
This PCIe-mini card is with PCIex1 signal and USB2.0 signal, please check
the signal compatibility and driver availability first.
After insert the PCIe-mini card module, please fix it by the provided screw.
And also install the related driver in the operating system to enable the functionality.

Change the Battery
The Battery is to keep BIOS setting and CMOS. Please change the battery
while the "BATT LOW" LED is on. The specification is as below
Model LED Status Definition
WISE-5580 PWR
Green System Power OK
Orange System Standby
WISE-54XX
PWR Green System Power OK
STBY Orange System Standby