WISE-4000 User Manual
42
Figure 3.11 USB Power Supply Wiring
3.3.3
I/O Units
The system uses a plug-in screw terminal block for the interface between I/O mod-
ules and field devices. The following information must be considered when connect-
ing electrical devices to I/O modules.
1.
The terminal block accepts wires from 0.5 mm to 2.5 mm.
2.
Always use a continuous length of wire. Do not combine wires.
3.
Use the shortest possible wire length.
4.
Use wire trays for routing where possible.
5.
Avoid running wires near high-energy wiring.
6.
Avoid running input wiring in close proximity to output wiring.
7.
Avoid creating sharp bends in the wires.
Summary of Contents for WISE-4000 Series
