Advantech TPC-B610, User Manual

Page: 20 / 76

TPC-B610 User Manual 8
2.1 Transport and Unpacking
2.1.1 Transport
When accepting a delivery, please check the packaging for visible transport damage
and check the delivery for completeness by comparing it with your order. If you notice
any shipping damage or inconsistencies between the contents and your order,
please inform the responsible delivery service immediately.
During transportation, the TPC should be protected from excessive mechanical
stress. If the TPC is transported or stored without packaging, shocks, vibrations,
pressure, and moisture may impact the unprotected unit. Damaged packaging indi -
cates that ambient conditions have already had a massive impact on the device.
Therefore, please use the original packaging during transportation and storage.
If the TPC is transported in cold weather or is exposed to extreme variations in tem
-
perature, make sure that moisture (condensation) does not build up on or inside the
HMI device. Moisture can result in short-circuits in electrical circuits and damage the
device. To avoid that, please store the TPC in a dry place and bring the TPC to room
temperature before starting it up. If condensation occurs, a delay time of approxi -
mately 12 hours must be allowed to make sure the TPC is completely dry before the
TPC is switched on.
2.1.2 Unpacking
1. Unpack the TPC-B610 package. Check the packing list at the beginning of this
manual to make sure all items have been included.
2. Connect the power connector (P/N: 1652006277-01) to the 24 VDC power lines.
The power lines can either be of some power adapter or in-house power source.
Figure 2.1 Power Connector
3. Plug the power lines into the system’s power receptor.
4. Attach power to the system.
5. Calibrate the touchscreen. (optional FPM-Display Module)