Advantech PPC-123, User Manual

Page: 144 / 174

PPC-123 User’s Manual 130
Appendix C Full Disassembly Proce-
dures
If you want to completely disassemble the panel PC, follow the step-by-
step procedures below. Users should be aware that Advantech Co., Ltd.
takes no responsibility whatsoever for any problems or damage caused by
the user disassembly of the panel PC. Make sure the power cord of the
panel PC is unplugged before you start disassembly.
The following procedures do not include the detailed disassembly proce-
dures for the CPU, HDD, CD-ROM drive, FDD, and SRAM; all of which
can be found in Chapter 4.
1.
Unscrew the seven screws on the rear cover, and remove it. The
PCI/ISA expansion slot cover can be detached by removing the two
additional screws.
2. Remove the side panel by pushing it outward.
3. Unscrew the four screws that attach the CPU cover.
4. Detach the flat cable of the HDD, FDD and CD-ROM drive.
Remove the two screws on the PCI/ISA bus expansion card.
Remove the ten screws on the side rim of the shielding case. Care-
fully move the shielding case to the right to bypass the eject buttons
of the PCMCIA slot, before removing the case from the machine.