Advantech PCM-9377, User Manual

Page: 36 / 128

PCM-9377 User Manual 22
resolution. To set up your video interface, please run the appropriate
installation program located on the utility disk.
2.20 Floppy drive connector (optional) (CN11)
You can attach up to two floppy drives to the PCM-9371.s onboard con-
troller. You can use 3.5.(720 KB, 1.44 MB, and 2.88 MB) drives. A 26-
pin FPC connector cable is required for a dual-drive system. On one end
of the cable is a 26-pin FPC-cable connector. One the other end are two
sets of floppy disk drive connectors. Each set consists of a 26-pin FPC-
cable connector (usually used for 3.5. drives).
2.20.1 Connecting the floppy drive
1. Plug the 26-pin FPC-cable connector into CN11. Make sure that the
red wire corresponds to pin one on the connector.
2. Attach the appropriate connector on the other end of the cable to the
floppy drives (s). You can use only one connector in the set. The set on
the end (after the twist in the cable) connects to the A: drive. The set in
the middle connects to the B: drive.
If you are connecting a 3.5. floppy drive, you may have trouble determin-
ing which pin is number one. Look for a number printed on the circuit
board indicating pin number one. In addition, the connector on the floppy
drive may have a slot. When the slot is up, pin number one should be on
the right. Check the documentation that came with the drive for more
information. If you desire, connect the B: drive to the connectors in the
middle of the cable as described above. In case you need to make your
own cable, you can find the pin assignments for the board’s connector in
Appendix A.
2.21 IR connector (CN18)
.
The board provides an IrDA port for transfer rates of 115 kbps. This con-
nector supports the optional wireless infrared transmitting and receiving
Table 2.11: TV Enable (J3)
Setting Function
Close TV-Enable
Open* TV-Disable
*: default