Advantech PCLS-848-P, User Manual

Page: 16 / 106

1 0 PCLS-848-P User's Manual
Jumper/Switch Selection Default setting
SW1 1-5 I/O port base address Hex 2B0
SW1 7-8 Wait states 0
SW2 Firmware base address Hex D000
SW3 Operating mode A
JP1 DACK level 1
JP2 DRQ level 1
JP3 IRQ level 7
Refer to Section 2.2. for other configurations.
2.3.2. Installing the Card into a PC
The procedure to install the IEEE-488 interface card is as following:
1. Turn off the computer and any peripheral devices (such as printers and monitors).
2. Disconnect the power cord and any other cables from the back of the computer.
Turn the system unit so the back of the unit faces you.
3. Remove the system unit cover (See your computer user’s guide if necessary).
4. Locate the expansion slots at the rear of the unit and choose any unused slot.
5. Remove the screw that secures the expansion slot cover to the system unit. (Save
the screw to secure the IEEE-488 interface card retaining bracket).
6. Carefully grasp the upper edge of the IEEE-488 interface card. Align the hole in the
retaining bracket with the hole on top of the expansion slot, and align the gold
striped edge connector with the expansion slot socket. Press the board firmly into
the socket.
7. Replace the screw in the expansion slot retaining bracket.
8. Replace the system unit cover. Connect the cables you removed in step 2.