Advantech PCE-5130, User Manual

Page: 58 / 102

PCE-5130 User Manual 46
! USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) controller
and you have USB peripherals. The choices are “Enabled” and “Disabled”.
! USB 2.0 Controller
This entry is to disable/enable the USB 2.0 controller only. The BIOS itself may/
may not have high-speed USB support. If the BIOS has high speed USB sup-
port built in, the support will automatically turn on when a high speed device is
attached. The choices are “Enabled” or “Disabled”.
! USB Keyboard / Mouse Support
Select Enabled if you plan to use an USB keyboard. The choices are “Enabled”
and “Disabled”.
! AC97 Audio
Select “Disable” if you do not want to use AC97 audio. Options are “Auto”, and
“Disabled”.
! Onboard LAN1 Control
Options are “Enabled” and “Disabled”. Select “Disabled” if you don’t want to use
onboard LAN controller1.
! Onboard LAN2 Control
Options are “Enabled” and “Disabled”. Select Disabled if you don’t want to use
the onboard LAN controller2.
Note: Correct sequence of onboard Lan controllers(Lan1 & Lan2) shows in the
"Onboard Device" BIOS view.
Figure 3.9 Super I/O Device
! Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to the
onboard floppy disk drive connector instead of a separate controller card. If you
want to use a different controller card to connect the floppy disk drives, set this
field to Disabled.
! Onboard Serial Port 1
The settings are “3F8/IRQ4”, “2F8/IRQ3”, “3E8/IRQ4”, “2E8/IRQ3”, and “Dis-
abled” for the on-board serial connector.
Note! DRAM default timings have been carefully chosen and should ONLY be
changed if data is being lost. Please first contact technical support.