Advantech MIC-5602, User Manual

Page: 70 / 74

MIC-5602 User Manual 58
7.1 Extracting a MIC-5602
1. Gently pull the handle switch on the front panel of the AMC. Do not pull the han-
dle out all the way yet. Pulling the handle switch notifies the MMC that you are
going to remove the AMC and notifies it to finish all processes. The hot swap
LED (blue) starts blinking.
2. Wait until the hot swap LED turns into a steady blue. This may take a few sec-
onds.
3. Pull the handle switch again more firmly and slide the AMC gently out of the
bay.
4. If you are not installing another AMC immediately, it is recommended that an
AMC filler be installed into the empty AMC slot. This is to ensure proper cooling
in the system.
7.2 Installing a MIC-5602
1. Check that the EMC gaskets on the front panel of the AMC are in place and that
their contacts are clean.
2. Insert the AMC into the chassis or carrier, sliding it along the guide rails gently til
it engages with the AMC connector or the MicroTCA backplane connector.
3. Push the handle switch all the way in. Wait until the blue hot swap LED turns off
and the power LED turns solid green.