Advantech IPPC-6172A Series, User Manual

Page: 15 / 76

9 IPPC-6172A User Manual
Chapter 2
S
ystem
Setup
2.1.4 USB Ports
An external USB device may be connected to the system via the 4-pin USB ports
located on the rear side of the system unit.
1. Connect the external device to the system.
2. The USB ports support hot plug-in connection. You should install the device
driver before you use the device.
2.1.5 Audio Interface
The audio interface includes three jacks: microphone-in, line-out and line-in. Their
functions are:
 Microphone-in: Use an external microphone to record voice and sound.
 Line-out: Output audio to external devices such as speakers or earphones. The
built-in speaker will not be disabled when the line-out jack is connected to exter-
nal audio devices.
 Line-in: Input audio from an external CD player or radio.
1. Connect the audio device to the system.
2. Install the driver before you use the device.
2.1.6 Ethernet
To install Ethernet for your system:
1. Connect the Ethernet cable.
2. Turn on the panel PC.
3. Run the Ethernet driver to connect up to the network.
2.2 Installing SDRAM
The Panel PC system provides two DDR3 SDRAM sockets. If users only need one
memory card, please insert the memory card into the first slot (near CPU).
1. Unlock the back cover and open it.
2. Push the two white eject levers on each side of the DIMM outward until they are
separated from the black vertical posts.
3. Insert the memory module into the socket at an angle of 90 degrees.
4. Push the two eject levers toward the vertical posts at each end of the socket
until the module is upright.