ICR-3231
6. First Use
6.1
Connecting the Router Before First Use
Before putting the router into operation it is necessary to connect all of the components
that are required to run your applications. Don’t forget to insert a SIM card.
The router can not operate without a connected antenna, SIM card and power supply. If
the antenna is not connected, the router may be damaged.
6.2
Start
The router will start when a power supply is connected to the router. By default, the router
will automatically start to log on to the default APN. The DHCP server will start to assign
addresses for devices connected through the Ethernet port ETH0. These router behaviors
can be changed via the web interface. This is described in detail in the
Configuration manual
for ICR-3200 routers
.
6.3
Configuration
Attention!
If no SIM card is inserted in the router, it is not possible for the router to
operate. Any inserted SIM card must have active data transmission.
6.3.1
Configuration by Web Browser
For status monitoring, configuration and administration of the router a web interface is
available which can be accessed by entering the IP address of the router into the web browser.
The default IP address of the router is 192.168.1.1.
Attention, it is necessary to use HTTPS
protocol for secure communication over a network!
Figure 23: Entering the IP address of the router
25
