Advantech EKI-9228G-8CMI, User Manual

Page: 107 / 324

89 EKI-9228G Series User Manual
The following table describes the items in the previous figure.
4.3.4.4 Copy
Use the Copy Configuration Files page to copy the information contained in one con-
figuration file to another configuration file on the device. When you click Submit, the
copy action takes place immediately, and the source file overwrites the destination
file.
To access this page, click System > Configuration Storage > Copy.
Figure 4.86 System > Configuration Storage > Copy
The following table describes the items in the previous figure.
4.3.5 Connectivity
4.3.5.1 IPv4
Use the IPv4 Network Connectivity page to configure and view the IPv4 network con-
nectivity information on the network interface. The network interface is the logical
interface that allows remote management of the device via any of the front-panel
switch ports. To enable management of the device over an IPv4 network by using a
Web browser, SNMP, Telnet, or SSH, you must first configure it with an IP address,
subnet mask, and default gateway. The configuration parameters associated with the
network interface do not affect the configuration of the front-panel ports through
which traffic is switched or routed.
Item Description
Reset Click Reset to initiate the action to erase the text-based configuration
file stored in non-volatile memory after displaying a confirmation mes-
sage. If the system resets and no startup-config file is found, the sys-
tem will begin the AutoInstall process to automatically update the
image and download a configuration file.
Item Description
Source File Select the configuration file that will overwrite the contents in the
selected destination file. The source file options are as follows:

Running Config: The file that contains the configuration that is
currently active on the system. Copying the Running Config file
to the Startup Config file is effectively the same as performing a
Save.

Startup Config: The file that contains the configuration that loads
when the system boots.

Backup Config: The file that is used to store a copy of the run-
ning or startup configuration.
Destination File Select file to be overwritten by the contents in the selected source file.
The destination file options are as follows:

Startup Config: The file that contains the configuration that loads
when the system boots.

Backup Config: The file that is used to store a copy of the run-
ning or startup configuration.
Submit Click Submit to save the values and update the screen.