41
EKI-6333AC-4GP User Manual
3.3.2
LAN & VLAN
3.3.2.1
Ethernet LAN
To access this page, click
Basic Network
>
LAN & VLAN
>
Ethernet LAN
.
Figure 3.36 Basic Network > LAN & VLAN > Ethernet LAN
The following table describes the items in the previous figure.
Policy
Check
Enable
checkbox to activate the policy rule.
Save
Click
Save
to save the settings.
Undo
Click
Undo
to cancel the settings.
Item
Description
Item
Description
IP Mode
It shows the LAN IP mode for the gateway according the related
configuration.
Static IP:
If there is at least one WAN interface activated, the
LAN IP mode is fixed in Static IP mode.
Dynamic IP:
If all the available WAN interfaces are disabled,
the LAN IP mode can be Dynamic IP mode.
LAN IP Address
Enter the local IP address of this device.
The network device(s) on your network must use the LAN IP
address of this device as their Default Gateway. You can change it
if necessary.
Note:
It’s also the IP address of web UI. If you change it, you need
to type new IP address in the browser to see web UI.
Subnet Mask
Select the subnet mask for this gateway from the drop-down
menu. Subnet mask defines how many clients are allowed in one
network or subnet.
The default subnet mask is 255.255.255.0 (/24), and it means
maximum 254 IP addresses are allowed in this subnet. However,
one of them is occupied by LAN IP address of this gateway, so
there are maximum 253 clients allowed in LAN network.
Value Range: 255.0.0.0 (/8) ~ 255.255.255.252 (/30).
Save
Click
Save
to save the settings.
Undo
Click
Undo
to cancel the settings.
