35
EKI-6333AC-4GP User Manual
When
WAN Type
is
PPTP
, the
PPTP WAN Type Configuration
appears.
Figure 3.29 Basic Network > WAN & Uplink > Connection Setup > PPTP WAN
Type Configuration
The following table describes the items in the previous figure.
Save
Click
Save
to save the settings.
Undo
Click
Undo
to cancel the settings.
Item
Description
IP Mode
Select either Static or Dynamic IP address for PPTP Internet
connection.
When
Static IP Address
is selected, you will need to enter
the WAN IP Address, WAN Subnet Mask, and WAN
Gateway.
–
WAN IP Address:
Enter the WAN IP address given by
your service provider.
–
WAN Subnet Mask:
Enter the WAN subnet mask given
by your service provider.
–
WAN Gateway:
Enter the WAN gateway IP address given
by your service provider.
When
Dynamic IP Address
is selected, there are no above
settings required.
Server IP Address /
Name
Enter the PPTP server name or IP Address.
PPTP Account
Enter the PPTP username provided by your service provider.
PPTP Password
Enter the PPTP connection password provided by your service
provider.
Connection ID
Enter a name to identify the PPTP connection.
Connection Control
There are three connection modes.
Auto-reconnect
enables the router to always keep the
Internet connection on.
Connect-on-demand
enables the router to automatically re-
establish Internet connection as soon as user attempts to
access the Internet. Internet connection will be disconnected
when it has been inactive for a specified idle time.
Connect Manually
allows user to connect to Internet
manually. Internet connection will be inactive after it has been
inactive for specified idle time.
MTU Setup
Check
Enable
checkbox to enable the MTU (Maximum
Transmission Unit) limit, and specify the MTU for the 3G/4G
connection.
MTU refers to Maximum Transmission Unit. It specifies the largest
packet size permitted for Internet transmission.
Value Range: 1200 ~ 1500.
Item
Description
