Advantech Automation1 XC4, Hardware Manual

Page: 97 / 120

3.3. Analog Outputs [-EB1]
The analog output can be set from within a program or it can be configured to echo the state of select
servo loop nodes.
The analog output is set to zero when you power on the system or reset the drive.
Table 3-11: Analog Output Specifications [-EB1]
Specification Value
Output Voltage -10 V to +10 V
Output Current 5 mA
Resolution (bits) 16 bits
Table 3-12: Analog Output Connector Pinout [-EB1]
Pin # Description In/Out/Bi
Connector
1 Analog Output 1 Output
2 Analog Output 2 Output
3 Analog Output 3 Output
4 Ground N/A
Table 3-13: Mating Connector Part Numbers for the Analog Output Connector [-EB1]
Type Aerotech P/N Third Party P/N
Wire Size: mm
2
[AWG]
4-Pin Terminal Block ECK02399 Phoenix 1768004 0.5- 0.14 [20-26]
Figure 3-8: Analog Output Typical Connection [-EB1]
XC4 Hardware Manual 3.3. Analog Outputs [-EB1]
www.aerotech.com 97