Advantech Automation1 XC4, Hardware Manual

Page: 29 / 120

2.1.2. Motor Supply Connector
Motor power is applied to the AC1 and AC2 terminals of the XC4 Motor Supply connector. The XC410
AC1 input is internally connected to a 5 A fuse. The XC420/30 AC1 input is internally connected to a 10 A
fuse. Refer to Table 5-4 for the internal fuse part numbers. The AC2 input is not internally fused. An
external fuse is required if AC2 is not connected to Neutral.
IMPORTANT : Before you operate the XC4, install a ground connection for your safety and
to prevent damage to the equipment.
For CE compliance, Aerotech recommends that you use an AC line filter. Connect the filter as close as
possible to the drive. For more information about the AC line filter, refer to
Section 2.1.4.
IMPORTANT : Refer to local electrical safety requirements to correctly size external system
wires.
Figure 2-2: Motor Supply Connections
Table 2-3: Motor Supply Connector Wiring Specifications
Pin Description Recommended Wire Size
AC1 0-240 VAC Motor Power Input
0.5 mm
2
(#20 AWG)
AC2 Neutral (N) or 240 VAC Motor Power Input with external fuse 0.5 mm
2
(#20 AWG)
Protective Ground 0.5 mm
2
(#20 AWG)
Table 2-4: Mating Connector Part Numbers for the Motor Supply Connector
Type
Aerotech
P/N
Third Part
P/N
Screw
Torque: Nm
Wire Size:
mm 2 [AWG]
7-Pin Terminal Block ECK02387 Phoenix 1756353 0.5 - 0.6 3.3 - 0.0516 [12-30]
XC4 Hardware Manual 2.1.2. Motor Supply Connector
www.aerotech.com 29