AIIS-1440 User Manual
4
1.3.13
Environment
Operating Temperature:
0 ~ 45
º
C (32 ~ 113
º
F)*
Non-operating Temperature:
-40 ~ 70
º
C (-40 ~ 158
º
F)
Operating Humidity:
10 ~ 95% @ 40
º
C, non-condensing
Non-operating Humidity:
10 ~ 95% @ 60
º
C, non-condensing
* Depends on CPU, i7 CPU supports 0 ~ 40
º
C.
1.3.14
Physical Characteristics
Dimension (WxHxD):
232 x 70 x 175 mm
Weight:
2.5Kg
1.3.15
EMC
CE, FCC, CCC, BSMI
1.3.16
Safety
UL, CB, CCC, BSMI
1.4
Jumper Settings
1.4.1
How to Set Jumpers
You can configure your motherboard to match the needs of your application by set-
ting the jumpers. A jumper is a metal bridge that closes an electrical circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To “close” (or turn ON) a jumper, you connect the pins
with the clip. To “open” (or turn OFF) a jumper, you remove the clip. Sometimes a
jumper consists of a set of three pins, labeled 1, 2 and 3. In this case you connect
either pins 1 and 2, or 2 and 3. A pair of needle-nose pliers may be useful when set-
ting jumpers.
1.4.2
BIOS CMOS (JCMOS1)
AIIS-1440 CPU card contains a jumper that can erase BIOS CMOS data and reset
the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset those data, set JCMOS1 to 2-3 closed for just a few sec-
onds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS to its last status or default setting.
Table 1.1: Clear BIOS CMOS (JCMOS1)
Function
Jumper Setting
*Keep BIOS CMOS data
1-2 closed
Clear BIOS CMOS data
2-3 closed
*default setting
1
2
3
1
2
3
Summary of Contents for AIIS-1440
