Advantech ACP-7000, User Manual

Page: 20 / 52

ACP-7000 User Manual 10
2.5 Hold-down Clamp
The hold-down clamp protects all the cards from vibration and shock. After installing
all the cards, re-fasten the hold-down clamp. Please refer to the following steps.
1. After plugging in the CPU card and add-on cards, please insert the rubber cush-
ions provided into the notches of the hold-down clamp, and adjust them to the
placement of the cards. The cushions offer these cards protection against shock
and vibration.
2. Put the hold-down clamp back into its original position. Please note that the cir-
cle hole on the hold-down clamp should face toward the rear panel. (See Figure
2.9).
3. Secure the hold-down clamp to the chassis with the four screws.
Figure 2.8 Installing hold-down clamp
Figure 2.9 The circle hole should face the rear panel