ADVANCED Network Devices IPBTN, Installation

Page: 1 / 2

Smart IP Button
(IPBTN) Installation
Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004
tech@anetd.com • 847-463- 2237 • www.anetd.com/
1
v2.2
MOUNT THE BUTTON DEVICE
•
Use device to mark installation location.
•
Choose the best location and orientation to
make the push button easy to access by the user,
as well as to connect the network cable.
•
Secure device using mounting hardware
appropriate for the installation surface.
•
Drywall: #8-32 steel screw x 1-5/8" min. length
fastened to a 75 lbs. rated drywall anchor, or
similar
•
Concrete: #8-32 steel screw x 5/8" min. length
fastened to a 8-32 concrete anchor with 9/16"
min. length, or similar
CONNECT TO THE NETWORK
•
Connect a network cable (CAT 5 or better) to the
RJ-45 port (PoE/PoE+).
•
Connect the other end of the network cable to
an LPS (Limited Power Source) PoE (Power over
Ethernet) network switch or PoE injector on a
network with a DHCP server.
ACCESS THE DEVICE
Use one of these ways to access the device:
•
Enter the IP address assigned by the DHCP server
in your browser.
•
Enter the IPv6 link-local address in your browser,
formatted as
http://[fe80::2246:f9ff:feXX:XXXX] (XX:XXXX =
last 6 digits of MAC address).
•
Double-click on the device in the IPClockWise
Endpoints list to open the web server interface.
•
For third-party software application, consult
guide for access method (often uses
configuration file).
CONFIGURE THE BUTTON
•
Set up the button to trigger notifications, alerts,
or other signal (see next page).
•
Consult the IPClockWise User Manual
(available
on the Customer Portal
www.anetd.com/portal/ ) or third-party
software guide for further instructions.
•
Test before putting it into service.
OPERATION
The front panel blue LED provides feedback on a
button push. The LED flashes upon the initial
button press. Once the device then connects to a
SIP phone or HTTP Callback server, the LED will
stop flashing and remain on solid for at least 5
seconds.
CONFIGURATION OPTIONS
The device ships with default settings:
SIP Mode "Button"
Push-to-Talk 1 Trigger Only "Yes”
Activate GPIO 0 During Active Call “Yes”
Send Activations Only “Yes”
GPIO 0 Output Pulse Time “5000”
GPIO 0 Output Blink Period “500”
Indicate GPO “0”
Indicate Trying Action “Blink”
Indicate Success Action “Pulse”
Configuration File Setup
<SIPConfig
SIP_mode="button"
push_to_talk_ip1_trigger_mode="1"
gpio0_when_active_call="1" />
<GPIO
pulse_ms_output_gpio0="5000"