When installing the reserve, always place the bridle in the reserve compartment first and then the inner container.
It is essential that the inner container closure flaps face the bottom (when in flight) of the harness. Follow the
directions indicated on the inner container and the inside of the reserve compartment. Silver dot to silver dot! The
connection to the reserve handle must be without twists.
Warning
If a reserve parachute does not fit in the inner container after repacking, it must be
refolded to the shape of the inner container.
Warning
Put the bridle in first, then the reserve.
Warning
Silver dot to silver dot!
4.2.4. Closing the reserve compartment
The outer container flaps are closed by loops and cable. Outer container design supplies the necessary tensions and
pressures on the closure loops and cable.
First thread two short packing assist lines through the left hand outer container flap white closure loops. Then
thread the right hand pack line through the metal eyelet of the right hand outer container flap and close it. The
right hand flap goes between the tongues of the left flap (Labyrinth closure). The Labyrinth closes itself with a
small magnet.
Now carefully run the right hand zip glider from right to left to its start, then close it from left to right, finally
stowing it in its «zipper garage».
Next the left hand zip, which closes the V-connection channel, is opened and closed as follows. Carefully run the
zipper all the way from top to bottom, to the end of the left side of the outer container. This is the actual start of
the zip. Then pull the zip slider up again and close the channel. The slider must be pulled all the way up to the end
of the track, and finally stowed in its own «zipper garage». Finally close the Velcro cover. This Velcro also
safeguards the zip fastener.
10 / 28
